AW: opening of 2 files with nc

[Schweikart, Matthias]

Hello,
thanks for your answer, but this doesn't work, because the tool by
itself generates the 2 nc commands.
Actually I'm trying to solve the problem by using a named pipe which
should change the 2 asynchronous nc calls to 2 synchronous nc calls.

Bye,
Matthias

Siemens AG
Industry Sector
Industry Automation Division
Advanced Technologies & Standards
I IA&DT ATS 22
Gleiwitzer Str. 555
90475 Nürnberg, Deutschland
Tel.: +49 (911) 895-3027 
Fax: +49 (911) 895-3762 
mailto:matthias.schweikart at siemens.com


Siemens Aktiengesellschaft: Vorsitzender des Aufsichtsrats: Gerhard Cromme; Vorstand: Peter Löscher, Vorsitzender; Wolfgang Dehen, Heinrich Hiesinger, Joe Kaeser, Barbara Kux, Hermann Requardt, Siegfried Russwurm, Peter Y. Solmssen; Sitz der Gesellschaft: Berlin und München, Deutschland; Registergericht: Berlin Charlottenburg, HRB 12300, München, HRB 6684; WEEE-Reg.-Nr. DE 23691322


-----Ursprüngliche Nachricht-----
Von: discuss-bounces at nedit.org [mailto:discuss-bounces at nedit.org] Im Auftrag von Offer Kaye
Gesendet: Freitag, 22. Mai 2009 18:20
An: General NEdit discussion list
Betreff: Re: opening of 2 files with nc

On Mon, May 18, 2009 at 11:59 AM, Schweikart, Matthias
<matthias.schweikart at siemens.com> wrote:
> Hello,
> I am working with a tool which uses nc to display textfiles.
> In some cases this tool tries to display 2 files simultaneously

Maybe add a "sleep 1;" command before the 2nd nc command?

-- 
Offer Kaye
-- 
NEdit Discuss mailing list - Discuss at nedit.org
http://www.nedit.org/mailman/listinfo/discuss